I am finally getting to scratch that itch to build something that I've had for a long while. I am building the Farmhouse Queen-size bed from Anna White's wonderful free plans. I have been a follower of hers since her blog was named, "Knock-Off Wood". Now it is just, "AnnaWhite.com", and if you're unfamiliar with it, please go and check it out - NOW! Then, come on back here. I wanted to share a couple of mistakes things I thought about before I started drilling into the wood to make this fabulous bed. For the panels, make sure that you position your pocket-holes (using the Kreg jig) close enough to the edge of the board so that they will be covered by the trim at the top and bottom of the panel when assembled. That is, if you decide to use the panels - this bed would look just as great with a flat plywood panel instead of the individual boards - a bit more urban, perhaps) Use the 'C' shaft for the right-side hole, and the 'A' shaft for the left side. For the 15" tall footboard panels, I only used two holes, but for the 30" tall headboard panels, I put a third hole at the center of the boards for stability, aligning the 'B' shaft at the 15" mark. These won't be seen from the front side of the headboard, since it will be against the wall. If you want to float your bed so that the back will be seen, you'll have to putty these center holes.
After drilling the holes, using the dust removal attachment that came with my Kreg Pocket-Hole Jig K4 Master System, I used my Porter Cable orbital sander to sand all edges and clean up the pocket holes. I decided to slightly round off the long edges of the front-side of the boards, so that the panels would be distinct. I figure, why bother using panels if you can't tell they're panels.
The bed is coming along. I'll post more pics as it progresses.
No comments:
Post a Comment